Antoine Ténart | 18b4bad | 2014-09-30 16:28:09 +0200 | [diff] [blame] | 1 | * Marvell PXA168 Ethernet Controller |
| 2 | |
| 3 | Required properties: |
| 4 | - compatible: should be "marvell,pxa168-eth". |
| 5 | - reg: address and length of the register set for the device. |
| 6 | - interrupts: interrupt for the device. |
| 7 | - clocks: pointer to the clock for the device. |
| 8 | |
| 9 | Optional properties: |
| 10 | - port-id: Ethernet port number. Should be '0','1' or '2'. |
| 11 | - #address-cells: must be 1 when using sub-nodes. |
| 12 | - #size-cells: must be 0 when using sub-nodes. |
| 13 | - phy-handle: see ethernet.txt file in the same directory. |
| 14 | - local-mac-address: see ethernet.txt file in the same directory. |
| 15 | |
| 16 | Sub-nodes: |
| 17 | Each PHY can be represented as a sub-node. This is not mandatory. |
| 18 | |
| 19 | Sub-nodes required properties: |
| 20 | - reg: the MDIO address of the PHY. |
| 21 | |
| 22 | Example: |
| 23 | |
| 24 | eth0: ethernet@f7b90000 { |
| 25 | compatible = "marvell,pxa168-eth"; |
| 26 | reg = <0xf7b90000 0x10000>; |
| 27 | clocks = <&chip CLKID_GETH0>; |
| 28 | interrupts = <GIC_SPI 24 IRQ_TYPE_LEVEL_HIGH>; |
| 29 | #address-cells = <1>; |
| 30 | #size-cells = <0>; |
| 31 | phy-handle = <ðphy0>; |
| 32 | |
| 33 | ethphy0: ethernet-phy@0 { |
| 34 | reg = <0>; |
| 35 | }; |
| 36 | }; |