solos-pci: Fix DMA support
DMA support has finally made its way to the top of the TODO list, having
realised that a Geode using MMIO can't keep up with two ADSL2+ lines
each running at 21Mb/s.
This patch fixes a couple of bugs in the DMA support in the driver, so
once the corresponding FPGA update is complete and tested everything
should work properly.
We weren't storing the currently-transmitting skb, so we were never
unmapping it and never freeing/popping it when the TX was done.
And the addition of pci_set_master() is fairly self-explanatory.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
Cc: stable@kernel.org
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/atm/solos-pci.c b/drivers/atm/solos-pci.c
index e8cd652..9851093 100644
--- a/drivers/atm/solos-pci.c
+++ b/drivers/atm/solos-pci.c
@@ -984,6 +984,7 @@
} else if (skb && card->using_dma) {
SKB_CB(skb)->dma_addr = pci_map_single(card->dev, skb->data,
skb->len, PCI_DMA_TODEVICE);
+ card->tx_skb[port] = skb;
iowrite32(SKB_CB(skb)->dma_addr,
card->config_regs + TX_DMA_ADDR(port));
}
@@ -1152,7 +1153,8 @@
db_fpga_upgrade = db_firmware_upgrade = 0;
}
- if (card->fpga_version >= DMA_SUPPORTED){
+ if (card->fpga_version >= DMA_SUPPORTED) {
+ pci_set_master(dev);
card->using_dma = 1;
} else {
card->using_dma = 0;