bcma: use chipcommon node from DT for SoC GPIO chip
This will allow us to define GPIO-attached devices (LEDs, buttons) in
the the device tree.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/Documentation/devicetree/bindings/bus/bcma.txt b/Documentation/devicetree/bindings/bus/bcma.txt
index e9070c1..62a4834 100644
--- a/Documentation/devicetree/bindings/bus/bcma.txt
+++ b/Documentation/devicetree/bindings/bus/bcma.txt
@@ -9,6 +9,11 @@
The cores on the AXI bus are automatically detected by bcma with the
memory ranges they are using and they get registered afterwards.
+The top-level axi bus may contain children representing attached cores
+(devices). This is needed since some hardware details can't be auto
+detected (e.g. IRQ numbers). Also some of the cores may be responsible
+for extra things, e.g. ChipCommon providing access to the GPIO chip.
+
Example:
axi@18000000 {
@@ -17,4 +22,11 @@
ranges = <0x00000000 0x18000000 0x00100000>;
#address-cells = <1>;
#size-cells = <1>;
+
+ chipcommon {
+ reg = <0x00000000 0x1000>;
+
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
};
diff --git a/drivers/bcma/driver_gpio.c b/drivers/bcma/driver_gpio.c
index 8ea497c..57ce5fe 100644
--- a/drivers/bcma/driver_gpio.c
+++ b/drivers/bcma/driver_gpio.c
@@ -218,6 +218,10 @@
#if IS_BUILTIN(CONFIG_BCM47XX)
chip->to_irq = bcma_gpio_to_irq;
#endif
+#if IS_BUILTIN(CONFIG_OF)
+ if (cc->core->bus->hosttype == BCMA_HOSTTYPE_SOC)
+ chip->of_node = cc->core->dev.of_node;
+#endif
switch (cc->core->bus->chipinfo.id) {
case BCMA_CHIP_ID_BCM5357:
case BCMA_CHIP_ID_BCM53572: