mfd: stmpe: Add reset support for all STMPE variant
Reset was only implemented for STMPE1801 variant despite
all variant have a SOFT_RESET bit.
For STMPE2401/2403/801/1601/1801 SOFT_RESET bit is bit 7
of SYS_CTRL register.
For STMPE610/811 (which have the same variant id) SOFT_RESET
bit is bit 1 of SYS_CTRL register.
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
diff --git a/drivers/mfd/stmpe.c b/drivers/mfd/stmpe.c
index c053b2b6..8500525 100644
--- a/drivers/mfd/stmpe.c
+++ b/drivers/mfd/stmpe.c
@@ -756,13 +756,22 @@
enable ? mask : 0);
}
-static int stmpe1801_reset(struct stmpe *stmpe)
+static int stmpe_reset(struct stmpe *stmpe)
{
+ u16 id_val = stmpe->variant->id_val;
unsigned long timeout;
int ret = 0;
+ u8 reset_bit;
+
+ if (id_val == STMPE811_ID)
+ /* STMPE801 and STMPE610 use bit 1 of SYS_CTRL register */
+ reset_bit = STMPE811_SYS_CTRL_RESET;
+ else
+ /* all other STMPE variant use bit 7 of SYS_CTRL register */
+ reset_bit = STMPE_SYS_CTRL_RESET;
ret = __stmpe_set_bits(stmpe, stmpe->regs[STMPE_IDX_SYS_CTRL],
- STMPE1801_MSK_SYS_CTRL_RESET, STMPE1801_MSK_SYS_CTRL_RESET);
+ reset_bit, reset_bit);
if (ret < 0)
return ret;
@@ -771,7 +780,7 @@
ret = __stmpe_reg_read(stmpe, stmpe->regs[STMPE_IDX_SYS_CTRL]);
if (ret < 0)
return ret;
- if (!(ret & STMPE1801_MSK_SYS_CTRL_RESET))
+ if (!(ret & reset_bit))
return 0;
usleep_range(100, 200);
}
@@ -1095,11 +1104,9 @@
if (ret)
return ret;
- if (id == STMPE1801_ID) {
- ret = stmpe1801_reset(stmpe);
- if (ret < 0)
- return ret;
- }
+ ret = stmpe_reset(stmpe);
+ if (ret < 0)
+ return ret;
if (stmpe->irq >= 0) {
if (id == STMPE801_ID)