NFC: trf7970a: Add ISO/IEC 15693 and Type 5 tag Support
Add support for ISO/IEC 15693 RF technology and Type 5 tags.
Note that Type 5 tags used to be referred to as Type V tags.
CC: Erick Macias <emacias@ti.com>
CC: Felipe Balbi <balbi@ti.com>
Signed-off-by: Mark A. Greer <mgreer@animalcreek.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/nfc/trf7970a.c b/drivers/nfc/trf7970a.c
index 516d0a6..d9babe9 100644
--- a/drivers/nfc/trf7970a.c
+++ b/drivers/nfc/trf7970a.c
@@ -85,10 +85,26 @@
* Unfortunately, that means that the driver has to peek into tx frames
* when the framing is 'NFC_DIGITAL_FRAMING_NFCA_T2T'. This is done by
* the trf7970a_per_cmd_config() routine.
+ *
+ * ISO/IEC 15693 frames specify whether to use single or double sub-carrier
+ * frequencies and whether to use low or high data rates in the flags byte
+ * of the frame. This means that the driver has to peek at all 15693 frames
+ * to determine what speed to set the communication to. In addition, write
+ * and lock commands use the OPTION flag to indicate that an EOF must be
+ * sent to the tag before it will send its response. So the driver has to
+ * examine all frames for that reason too.
+ *
+ * It is unclear how long to wait before sending the EOF. According to the
+ * Note under Table 1-1 in section 1.6 of
+ * http://www.ti.com/lit/ug/scbu011/scbu011.pdf, that wait should be at least
+ * 10 ms for TI Tag-it HF-I tags; however testing has shown that is not long
+ * enough. For this reason, the driver waits 20 ms which seems to work
+ * reliably.
*/
#define TRF7970A_SUPPORTED_PROTOCOLS \
- (NFC_PROTO_MIFARE_MASK | NFC_PROTO_ISO14443_MASK)
+ (NFC_PROTO_MIFARE_MASK | NFC_PROTO_ISO14443_MASK | \
+ NFC_PROTO_ISO15693_MASK)
/* TX data must be prefixed with a FIFO reset cmd, a cmd that depends
* on what the current framing is, the address of the TX length byte 1
@@ -106,6 +122,7 @@
#define TRF7970A_WAIT_FOR_RX_DATA_TIMEOUT 5
#define TRF7970A_WAIT_FOR_FIFO_DRAIN_TIMEOUT 3
+#define TRF7970A_WAIT_TO_ISSUE_ISO15693_EOF 20
/* Quirks */
/* Erratum: When reading IRQ Status register on trf7970a, we must issue a
@@ -265,6 +282,36 @@
/* NFC (ISO/IEC 14443A) Type 2 Tag commands */
#define NFC_T2T_CMD_READ 0x30
+/* ISO 15693 commands codes */
+#define ISO15693_CMD_INVENTORY 0x01
+#define ISO15693_CMD_READ_SINGLE_BLOCK 0x20
+#define ISO15693_CMD_WRITE_SINGLE_BLOCK 0x21
+#define ISO15693_CMD_LOCK_BLOCK 0x22
+#define ISO15693_CMD_READ_MULTIPLE_BLOCK 0x23
+#define ISO15693_CMD_WRITE_MULTIPLE_BLOCK 0x24
+#define ISO15693_CMD_SELECT 0x25
+#define ISO15693_CMD_RESET_TO_READY 0x26
+#define ISO15693_CMD_WRITE_AFI 0x27
+#define ISO15693_CMD_LOCK_AFI 0x28
+#define ISO15693_CMD_WRITE_DSFID 0x29
+#define ISO15693_CMD_LOCK_DSFID 0x2a
+#define ISO15693_CMD_GET_SYSTEM_INFO 0x2b
+#define ISO15693_CMD_GET_MULTIPLE_BLOCK_SECURITY_STATUS 0x2c
+
+/* ISO 15693 request and response flags */
+#define ISO15693_REQ_FLAG_SUB_CARRIER BIT(0)
+#define ISO15693_REQ_FLAG_DATA_RATE BIT(1)
+#define ISO15693_REQ_FLAG_INVENTORY BIT(2)
+#define ISO15693_REQ_FLAG_PROTOCOL_EXT BIT(3)
+#define ISO15693_REQ_FLAG_SELECT BIT(4)
+#define ISO15693_REQ_FLAG_AFI BIT(4)
+#define ISO15693_REQ_FLAG_ADDRESS BIT(5)
+#define ISO15693_REQ_FLAG_NB_SLOTS BIT(5)
+#define ISO15693_REQ_FLAG_OPTION BIT(6)
+
+#define ISO15693_REQ_FLAG_SPEED_MASK \
+ (ISO15693_REQ_FLAG_SUB_CARRIER | ISO15693_REQ_FLAG_DATA_RATE)
+
enum trf7970a_state {
TRF7970A_ST_OFF,
TRF7970A_ST_IDLE,
@@ -272,6 +319,7 @@
TRF7970A_ST_WAIT_FOR_TX_FIFO,
TRF7970A_ST_WAIT_FOR_RX_DATA,
TRF7970A_ST_WAIT_FOR_RX_DATA_CONT,
+ TRF7970A_ST_WAIT_TO_ISSUE_EOF,
TRF7970A_ST_MAX
};
@@ -293,6 +341,7 @@
int technology;
int framing;
u8 tx_cmd;
+ bool issue_eof;
int en2_gpio;
int en_gpio;
struct mutex lock;
@@ -454,8 +503,13 @@
trf->state = TRF7970A_ST_WAIT_FOR_TX_FIFO;
timeout = TRF7970A_WAIT_FOR_FIFO_DRAIN_TIMEOUT;
} else {
- trf->state = TRF7970A_ST_WAIT_FOR_RX_DATA;
- timeout = trf->timeout;
+ if (trf->issue_eof) {
+ trf->state = TRF7970A_ST_WAIT_TO_ISSUE_EOF;
+ timeout = TRF7970A_WAIT_TO_ISSUE_ISO15693_EOF;
+ } else {
+ trf->state = TRF7970A_ST_WAIT_FOR_RX_DATA;
+ timeout = trf->timeout;
+ }
}
dev_dbg(trf->dev, "Setting timeout for %d ms, state: %d\n", timeout,
@@ -631,6 +685,10 @@
trf7970a_send_err_upstream(trf, -EIO);
}
break;
+ case TRF7970A_ST_WAIT_TO_ISSUE_EOF:
+ if (status != TRF7970A_IRQ_STATUS_TX)
+ trf7970a_send_err_upstream(trf, -EIO);
+ break;
default:
dev_err(trf->dev, "%s - Driver in invalid state: %d\n",
__func__, trf->state);
@@ -640,6 +698,29 @@
return IRQ_HANDLED;
}
+static void trf7970a_issue_eof(struct trf7970a *trf)
+{
+ int ret;
+
+ dev_dbg(trf->dev, "Issuing EOF\n");
+
+ ret = trf7970a_cmd(trf, TRF7970A_CMD_FIFO_RESET);
+ if (ret)
+ trf7970a_send_err_upstream(trf, ret);
+
+ ret = trf7970a_cmd(trf, TRF7970A_CMD_EOF);
+ if (ret)
+ trf7970a_send_err_upstream(trf, ret);
+
+ trf->state = TRF7970A_ST_WAIT_FOR_RX_DATA;
+
+ dev_dbg(trf->dev, "Setting timeout for %d ms, state: %d\n",
+ trf->timeout, trf->state);
+
+ schedule_delayed_work(&trf->timeout_work,
+ msecs_to_jiffies(trf->timeout));
+}
+
static void trf7970a_timeout_work_handler(struct work_struct *work)
{
struct trf7970a *trf = container_of(work, struct trf7970a,
@@ -654,6 +735,8 @@
trf->ignore_timeout = false;
else if (trf->state == TRF7970A_ST_WAIT_FOR_RX_DATA_CONT)
trf7970a_send_upstream(trf); /* No more rx data so send up */
+ else if (trf->state == TRF7970A_ST_WAIT_TO_ISSUE_EOF)
+ trf7970a_issue_eof(trf);
else
trf7970a_send_err_upstream(trf, -ETIMEDOUT);
@@ -801,6 +884,9 @@
case NFC_DIGITAL_RF_TECH_106A:
trf->iso_ctrl = TRF7970A_ISO_CTRL_14443A_106;
break;
+ case NFC_DIGITAL_RF_TECH_ISO15693:
+ trf->iso_ctrl = TRF7970A_ISO_CTRL_15693_SGL_1OF4_2648;
+ break;
default:
dev_dbg(trf->dev, "Unsupported rf technology: %d\n", tech);
return -EINVAL;
@@ -823,6 +909,8 @@
break;
case NFC_DIGITAL_FRAMING_NFCA_STANDARD_WITH_CRC_A:
case NFC_DIGITAL_FRAMING_NFCA_T4T:
+ case NFC_DIGITAL_FRAMING_ISO15693_INVENTORY:
+ case NFC_DIGITAL_FRAMING_ISO15693_T5T:
trf->tx_cmd = TRF7970A_CMD_TRANSMIT;
trf->iso_ctrl &= ~TRF7970A_ISO_CTRL_RX_CRC_N;
break;
@@ -873,15 +961,39 @@
return ret;
}
+static int trf7970a_is_iso15693_write_or_lock(u8 cmd)
+{
+ switch (cmd) {
+ case ISO15693_CMD_WRITE_SINGLE_BLOCK:
+ case ISO15693_CMD_LOCK_BLOCK:
+ case ISO15693_CMD_WRITE_MULTIPLE_BLOCK:
+ case ISO15693_CMD_WRITE_AFI:
+ case ISO15693_CMD_LOCK_AFI:
+ case ISO15693_CMD_WRITE_DSFID:
+ case ISO15693_CMD_LOCK_DSFID:
+ return 1;
+ break;
+ default:
+ return 0;
+ }
+}
+
static int trf7970a_per_cmd_config(struct trf7970a *trf, struct sk_buff *skb)
{
u8 *req = skb->data;
- u8 special_fcn_reg1;
+ u8 special_fcn_reg1, iso_ctrl;
int ret;
+ trf->issue_eof = false;
+
/* When issuing Type 2 read command, make sure the '4_bit_RX' bit in
* special functions register 1 is cleared; otherwise, its a write or
* sector select command and '4_bit_RX' must be set.
+ *
+ * When issuing an ISO 15693 command, inspect the flags byte to see
+ * what speed to use. Also, remember if the OPTION flag is set on
+ * a Type 5 write or lock command so the driver will know that it
+ * has to send an EOF in order to get a response.
*/
if ((trf->technology == NFC_DIGITAL_RF_TECH_106A) &&
(trf->framing == NFC_DIGITAL_FRAMING_NFCA_T2T)) {
@@ -898,6 +1010,37 @@
trf->special_fcn_reg1 = special_fcn_reg1;
}
+ } else if (trf->technology == NFC_DIGITAL_RF_TECH_ISO15693) {
+ iso_ctrl = trf->iso_ctrl & ~TRF7970A_ISO_CTRL_RFID_SPEED_MASK;
+
+ switch (req[0] & ISO15693_REQ_FLAG_SPEED_MASK) {
+ case 0x00:
+ iso_ctrl |= TRF7970A_ISO_CTRL_15693_SGL_1OF4_662;
+ break;
+ case ISO15693_REQ_FLAG_SUB_CARRIER:
+ iso_ctrl |= TRF7970A_ISO_CTRL_15693_DBL_1OF4_667a;
+ break;
+ case ISO15693_REQ_FLAG_DATA_RATE:
+ iso_ctrl |= TRF7970A_ISO_CTRL_15693_SGL_1OF4_2648;
+ break;
+ case (ISO15693_REQ_FLAG_SUB_CARRIER |
+ ISO15693_REQ_FLAG_DATA_RATE):
+ iso_ctrl |= TRF7970A_ISO_CTRL_15693_DBL_1OF4_2669;
+ break;
+ }
+
+ if (iso_ctrl != trf->iso_ctrl) {
+ ret = trf7970a_write(trf, TRF7970A_ISO_CTRL, iso_ctrl);
+ if (ret)
+ return ret;
+
+ trf->iso_ctrl = iso_ctrl;
+ }
+
+ if ((trf->framing == NFC_DIGITAL_FRAMING_ISO15693_T5T) &&
+ trf7970a_is_iso15693_write_or_lock(req[1]) &&
+ (req[0] & ISO15693_REQ_FLAG_OPTION))
+ trf->issue_eof = true;
}
return 0;
@@ -1185,6 +1328,7 @@
case TRF7970A_ST_WAIT_FOR_TX_FIFO:
case TRF7970A_ST_WAIT_FOR_RX_DATA:
case TRF7970A_ST_WAIT_FOR_RX_DATA_CONT:
+ case TRF7970A_ST_WAIT_TO_ISSUE_EOF:
trf7970a_send_err_upstream(trf, -ECANCELED);
break;
default: