iommu/omap: Allow enable/disable even without pdata
When booting with a devicetree, no platform data is provided.
Do not prematurely exit iommu_enable() and iommu_disable() in
such a case.
Note: As OMAP do not yet has a proper reset controller driver,
IOMMUs requiring a reset signal should use pdata-quirks as a
transitional solution.
Signed-off-by: Florian Vaussard <florian.vaussard@epfl.ch>
Signed-off-by: Suman Anna <s-anna@ti.com>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Joerg Roedel <joro@8bytes.org>
diff --git a/drivers/iommu/omap-iommu.c b/drivers/iommu/omap-iommu.c
index 647e4ba..217952b 100644
--- a/drivers/iommu/omap-iommu.c
+++ b/drivers/iommu/omap-iommu.c
@@ -146,13 +146,10 @@
struct platform_device *pdev = to_platform_device(obj->dev);
struct iommu_platform_data *pdata = pdev->dev.platform_data;
- if (!pdata)
- return -EINVAL;
-
if (!arch_iommu)
return -ENODEV;
- if (pdata->deassert_reset) {
+ if (pdata && pdata->deassert_reset) {
err = pdata->deassert_reset(pdev, pdata->reset_name);
if (err) {
dev_err(obj->dev, "deassert_reset failed: %d\n", err);
@@ -172,14 +169,11 @@
struct platform_device *pdev = to_platform_device(obj->dev);
struct iommu_platform_data *pdata = pdev->dev.platform_data;
- if (!pdata)
- return;
-
arch_iommu->disable(obj);
pm_runtime_put_sync(obj->dev);
- if (pdata->assert_reset)
+ if (pdata && pdata->assert_reset)
pdata->assert_reset(pdev, pdata->reset_name);
}