of: Always use 'struct device.of_node' to get device node pointer.
The following structure elements duplicate the information in
'struct device.of_node' and so are being eliminated. This patch
makes all readers of these elements use device.of_node instead.
(struct of_device *)->node
(struct dev_archdata *)->prom_node (sparc)
(struct dev_archdata *)->of_node (powerpc & microblaze)
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/ata/pata_mpc52xx.c b/drivers/ata/pata_mpc52xx.c
index 9f5b053..4cce719 100644
--- a/drivers/ata/pata_mpc52xx.c
+++ b/drivers/ata/pata_mpc52xx.c
@@ -694,7 +694,7 @@
struct bcom_task *dmatsk = NULL;
/* Get ipb frequency */
- ipb_freq = mpc5xxx_get_bus_frequency(op->node);
+ ipb_freq = mpc5xxx_get_bus_frequency(op->dev.of_node);
if (!ipb_freq) {
dev_err(&op->dev, "could not determine IPB bus frequency\n");
return -ENODEV;
@@ -702,7 +702,7 @@
/* Get device base address from device tree, request the region
* and ioremap it. */
- rv = of_address_to_resource(op->node, 0, &res_mem);
+ rv = of_address_to_resource(op->dev.of_node, 0, &res_mem);
if (rv) {
dev_err(&op->dev, "could not determine device base address\n");
return rv;
@@ -735,14 +735,14 @@
* The MPC5200 ATA controller supports MWDMA modes 0, 1 and 2 and
* UDMA modes 0, 1 and 2.
*/
- prop = of_get_property(op->node, "mwdma-mode", &proplen);
+ prop = of_get_property(op->dev.of_node, "mwdma-mode", &proplen);
if ((prop) && (proplen >= 4))
mwdma_mask = ATA_MWDMA2 & ((1 << (*prop + 1)) - 1);
- prop = of_get_property(op->node, "udma-mode", &proplen);
+ prop = of_get_property(op->dev.of_node, "udma-mode", &proplen);
if ((prop) && (proplen >= 4))
udma_mask = ATA_UDMA2 & ((1 << (*prop + 1)) - 1);
- ata_irq = irq_of_parse_and_map(op->node, 0);
+ ata_irq = irq_of_parse_and_map(op->dev.of_node, 0);
if (ata_irq == NO_IRQ) {
dev_err(&op->dev, "error mapping irq\n");
return -EINVAL;