md: cancel check/repair requests when recovery is needed
If a 'repair' is requested when an array is in a position to 'recover' raid1
will perform the repair while md believes a recovery is happening. Address
this at both ends, i.e. cancel check/repair requests upon detecting a
recover condition and do not call ->spare_active after completing a
check/repair.
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
diff --git a/drivers/md/md.c b/drivers/md/md.c
index 25b893e..8cfadc5 100644
--- a/drivers/md/md.c
+++ b/drivers/md/md.c
@@ -6138,7 +6138,8 @@
/* resync has finished, collect result */
md_unregister_thread(mddev->sync_thread);
mddev->sync_thread = NULL;
- if (!test_bit(MD_RECOVERY_INTR, &mddev->recovery)) {
+ if (!test_bit(MD_RECOVERY_INTR, &mddev->recovery) &&
+ !test_bit(MD_RECOVERY_REQUESTED, &mddev->recovery)) {
/* success...*/
/* activate any spares */
if (mddev->pers->spare_active(mddev))
@@ -6190,6 +6191,7 @@
} else if ((spares = remove_and_add_spares(mddev))) {
clear_bit(MD_RECOVERY_SYNC, &mddev->recovery);
clear_bit(MD_RECOVERY_CHECK, &mddev->recovery);
+ clear_bit(MD_RECOVERY_REQUESTED, &mddev->recovery);
set_bit(MD_RECOVERY_RECOVER, &mddev->recovery);
} else if (mddev->recovery_cp < MaxSector) {
set_bit(MD_RECOVERY_SYNC, &mddev->recovery);