[PATCH] i386: inline assembler: cleanup and encapsulate descriptor and task register management
i386 inline assembler cleanup.
This change encapsulates descriptor and task register management. Also,
it is possible to improve assembler generation in two cases; savesegment
may store the value in a register instead of a memory location, which
allows GCC to optimize stack variables into registers, and MOV MEM, SEG
is always a 16-bit write to memory, making the casting in math-emu
unnecessary.
Signed-off-by: Zachary Amsden <zach@vmware.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/arch/i386/kernel/reboot.c b/arch/i386/kernel/reboot.c
index c71fef3..1cbb9c0 100644
--- a/arch/i386/kernel/reboot.c
+++ b/arch/i386/kernel/reboot.c
@@ -13,6 +13,7 @@
#include <linux/dmi.h>
#include <asm/uaccess.h>
#include <asm/apic.h>
+#include <asm/desc.h>
#include "mach_reboot.h"
#include <linux/reboot_fixups.h>
@@ -242,13 +243,13 @@
/* Set up the IDT for real mode. */
- __asm__ __volatile__ ("lidt %0" : : "m" (real_mode_idt));
+ load_idt(&real_mode_idt);
/* Set up a GDT from which we can load segment descriptors for real
mode. The GDT is not used in real mode; it is just needed here to
prepare the descriptors. */
- __asm__ __volatile__ ("lgdt %0" : : "m" (real_mode_gdt));
+ load_gdt(&real_mode_gdt);
/* Load the data segment registers, and thus the descriptors ready for
real mode. The base address of each segment is 0x100, 16 times the
@@ -316,7 +317,7 @@
if (!reboot_thru_bios) {
if (efi_enabled) {
efi.reset_system(EFI_RESET_COLD, EFI_SUCCESS, 0, NULL);
- __asm__ __volatile__("lidt %0": :"m" (no_idt));
+ load_idt(&no_idt);
__asm__ __volatile__("int3");
}
/* rebooting needs to touch the page at absolute addr 0 */
@@ -325,7 +326,7 @@
mach_reboot_fixups(); /* for board specific fixups */
mach_reboot();
/* That didn't work - force a triple fault.. */
- __asm__ __volatile__("lidt %0": :"m" (no_idt));
+ load_idt(&no_idt);
__asm__ __volatile__("int3");
}
}