bcma: move flash detection code to ChipCommon core driver
Flashes are attached and accessible through ChipCommon core, they aren't
connected to MIPS one. Moreover some new ARM devices (e.g. BCM47189) may
have serial flash accessibility using ChipCommon registers as well. To
support them we can't keep this code in MIPS core driver.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
diff --git a/drivers/bcma/driver_mips.c b/drivers/bcma/driver_mips.c
index 967b0e8..96f1713 100644
--- a/drivers/bcma/driver_mips.c
+++ b/drivers/bcma/driver_mips.c
@@ -250,34 +250,11 @@
return BCMA_BOOT_DEV_SERIAL;
}
-static void bcma_core_mips_flash_detect(struct bcma_drv_mips *mcore)
+static void bcma_core_mips_nvram_init(struct bcma_drv_mips *mcore)
{
struct bcma_bus *bus = mcore->core->bus;
- struct bcma_drv_cc *cc = &bus->drv_cc;
enum bcma_boot_dev boot_dev;
- switch (cc->capabilities & BCMA_CC_CAP_FLASHT) {
- case BCMA_CC_FLASHT_STSER:
- case BCMA_CC_FLASHT_ATSER:
- bcma_debug(bus, "Found serial flash\n");
- bcma_sflash_init(cc);
- break;
- case BCMA_CC_FLASHT_PARA:
- bcma_debug(bus, "Found parallel flash\n");
- bcma_pflash_init(cc);
- break;
- default:
- bcma_err(bus, "Flash type not supported\n");
- }
-
- if (cc->core->id.rev == 38 ||
- bus->chipinfo.id == BCMA_CHIP_ID_BCM4706) {
- if (cc->capabilities & BCMA_CC_CAP_NFLASH) {
- bcma_debug(bus, "Found NAND flash\n");
- bcma_nflash_init(cc);
- }
- }
-
/* Determine flash type this SoC boots from */
boot_dev = bcma_boot_dev(bus);
switch (boot_dev) {
@@ -304,7 +281,7 @@
if (mcore->early_setup_done)
return;
- bcma_core_mips_flash_detect(mcore);
+ bcma_core_mips_nvram_init(mcore);
mcore->early_setup_done = true;
}