cpufreq: elanfreq: Use generic cpufreq routines
Most of the CPUFreq drivers do similar things in .exit() and .verify() routines
and .attr. So its better if we have generic routines for them which can be used
by cpufreq drivers then.
This patch uses these generic routines in the elanfreq driver.
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/cpufreq/elanfreq.c b/drivers/cpufreq/elanfreq.c
index 4000c34..fe7053c 100644
--- a/drivers/cpufreq/elanfreq.c
+++ b/drivers/cpufreq/elanfreq.c
@@ -165,19 +165,6 @@
};
-/**
- * elanfreq_validatespeed: test if frequency range is valid
- * @policy: the policy to validate
- *
- * This function checks if a given frequency range in kHz is valid
- * for the hardware supported by the driver.
- */
-
-static int elanfreq_verify(struct cpufreq_policy *policy)
-{
- return cpufreq_frequency_table_verify(policy, &elanfreq_table[0]);
-}
-
static int elanfreq_target(struct cpufreq_policy *policy,
unsigned int target_freq,
unsigned int relation)
@@ -226,13 +213,6 @@
}
-static int elanfreq_cpu_exit(struct cpufreq_policy *policy)
-{
- cpufreq_frequency_table_put_attr(policy->cpu);
- return 0;
-}
-
-
#ifndef MODULE
/**
* elanfreq_setup - elanfreq command line parameter parsing
@@ -255,20 +235,14 @@
#endif
-static struct freq_attr *elanfreq_attr[] = {
- &cpufreq_freq_attr_scaling_available_freqs,
- NULL,
-};
-
-
static struct cpufreq_driver elanfreq_driver = {
.get = elanfreq_get_cpu_frequency,
- .verify = elanfreq_verify,
+ .verify = cpufreq_generic_frequency_table_verify,
.target = elanfreq_target,
.init = elanfreq_cpu_init,
- .exit = elanfreq_cpu_exit,
+ .exit = cpufreq_generic_exit,
.name = "elanfreq",
- .attr = elanfreq_attr,
+ .attr = cpufreq_generic_attr,
};
static const struct x86_cpu_id elan_id[] = {